Your ROAM-LR device is factory-set with both the Transmitter and Receiver addresses configured to 1. For enhanced security, you may change the address to any value between 0 and 127 by following the steps outlined below.
- If the unit is off (no display), power the Transmitter up by pressing the Blue Mode button.
- Press and hold the Blue Mode button until the key appears.
- Ensure that the transmitter Address is set to the desired address using the Up and Down buttons.
- Plug the receiver into a SmartPort® connected to a powered controller.
- After four beeps, press the > button to activate four additional beeps.
- Pairing is now complete. Test the remote by activating a zone.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.