Remotes

Welcome to the Remotes Support section. Here you will find informative videos and owner's manuals with instructions for installing and operating your Hunter irrigation remote.

  • Owner's Manuals
    The Remote Owner's Manual will guide you through the installation, wiring, and operation of each of the irrigation remotes.
  • Specifications
    ModelAddress RangeMax StationsRun TimeRangeSystem Operating frequencySRR0 – 127471-30 minutesup to 450 ft (137 m)315MHzRoam0 – 1272401–90 minutesup to 1,000 ft (300 m)433.925
  • Wiring
    This Support Article is dedicated to the installation guidelines of our remote control kit.To utilize the Remote Control Systems, your controller must be equipped with a Smartport
  • ROAM-LR Installation
    Included Components:ReceiverTransmitterSmartPort® Wiring Harness4 AAA BatteriesCarrying Case
  • Roam
    Both the ROAM Transmitter and Receiver have an “address” that they use when communicating. If the addresses do not match, the receiver will ignore the transmission. Your ROAM comes
  • Roam XL
    Your ROAM XL System is pre-addressed to work right out of the box. However, if you changed the Transmitter address as described in the section, Preparing the Transmitter For Use",
  • Roam LR
    Your ROAM-LR device is factory-set with both the Transmitter and Receiver addresses configured to 1. For enhanced security, you may change the address to any value between 0 and
  • ICR
    Your ICR Transmitter comes from the factory with the maximum number of stations set to 9. This means that when you use the UP or DOWN buttons to change the station, you may change
  • Roam XL
    The ROAM-XL Remote is equipped with two distinct operating modes, each supporting a different number of stations. To ensure proper functionality and compatibility, the mode should
  • Roam LR
    The ROAM-LR Remote is equipped with two distinct operating modes, each supporting a different number of stations. To ensure proper functionality and compatibility, the mode should
  • Roam
    Adjust the amount of time a station runs before it is turned on by your ROAM System. This does not affect the run time programmed into your controller. There are 10 preset run
  • Roam LR
    Adjust the amount of time a station runs before it is turned on by your ROAM LR System. This does not affect the run time programmed into your controller. There are 10 preset run
  • Reset Roam XL
  • ERR Messages
    When using a ROAM, ROAM-XL, ICR, or SRR remote, you may come across a controller that gives you an ERR or SP ERR message. There are two reasons that would cause one of these

Find Hunter